STUDI PENGGUNAAN PASIR DHARMASRAYA DAN PENAMBAHAN CANGKANG SAWIT SEBAGAI AGREGAT KASAR TERHADAP KUAT TEKAN BETON NORMAL

Arman A, Made Lesmana Gandi

Sari


Concrete is a mixture between coarse aggregate, fine aggregate, cement and water. Pembuatan beton normal diinovasikan denganusing Dharmasraya sand and palm shell as a coarse aggregate against the strength of normal concrete press. Palm shell waste is mostly used as an alternative fossil replacement energy commonly used as fuel in steam power plants, and Dareh River is a river where it is made into gold and sand mines and this research is experimental which is carried out in the laboratory of Padang Institute of Technology and UPTD Laboratory of construction materials of the Public Works Office of West Sumatra Province, the object of this research is the minimum quality of concrete K-250 that uses sand from Dharmasraya and palm shells. The average concrete press strength result at the age of 3 days.from the use of mixtures for normal concrete with an average press strength of 207 kg / cm2, from the use of mixtures for concrete with an additional 2.5% palm shell obtained an average press strength yield of 163 kg / cm2, from the use of mixtures for concrete with an additional 5% palm shell obtained an average press strength yield of 136.3 kg / cm2, fromthe use of mixtures for concrete with an additional 7.5% palm shell obtained an average press strength yield of 146 kg / cm2. While at the age of 28 days, from the use of mixtures for normal concrete obtained an average press strength yield of 307.3 kg/cm2 with an additional 2.5% palm shell obtained an average press strength yield of 308 kg/cm2,fromthe use of mixtures for concrete with an additional 5 % of palm shell obtained an average press strength of 331.3 kg/cm2, from the use of mixtures for concrete with an additional 7.5% palm shell obtained an average press strength yield of 239.3 kg / cm2.

Keywords: Palm Shell, Strong Press Normal Concrete, Dharmasraya Sand.


Teks Lengkap:

PDF

Referensi


AASHTO T 27, 2014. Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates.

Dipohusodo, Istimawan, 2000, “Strtuktur Beton” Yoga : Jakarta

Haristha, Yosi, and Elfania Bastian. "ANALISIS PENGARUH PENAMBAHAN IJUK 0, 25% DAN 0, 5% PADA CAMPURAN BETON fc’14, 5 MPa (NON STRUKTUR)." Rang Teknik Journal 5.1 (2022): 77-82.

Kardiyono, Tjokrodimuljo, 1992, “Teknologi Beton” Jurusan Teknik Sipil, Fakultas Teknik, UGM, Yogyakarta

Kristanto, 2013, “Pengaruh Penggunaan Cangkang Sawit Sebagai Bahan Tambah Terhadap Mutu Beton”

Laksmi, B.T, 1999, “Penanganan Limbah Industri”, Kanisius: Jakarta.

Mulyono, Tri, 2004, “Teknologi Beton”, Andi : Yogyakarta

Nawy, 1985, Material Pembentuk Beton”

SK SNI 2847-2013. Persyaratan Beton Untuk Bangunan Gedung

SK SNI M-02-1989-F, 1989. Standar Metode Pengambilan Contoh Uji Kualitas Air, Yayasan Lembaga Penyelidikan Masalah Bangunan, Bandung.

SK SNI T-15-1991-03, 1991. Tata Cara Perhitungan Struktur Beton Untuk Bangunan Gedung, Departemen Pekerjaan Umum Yayasan LPMB, Bandung.

SNI 03-6817-2002, 2002. Metode Pengujian Mutu Air Untuk Digunakan dalam Beton, Badan Standar Nasional.

SNI 03-2493-1991, 1991. Metoda Pembuatan dan Perawatan Benda Uji Beton di Laboratorium, Badan Standar Nasional.

SK SNI 03–6468–2000, 2000. Perencanaa Campuran Tinggi dengan Semen Portland dengan Abuterbang, Badan Standar Nasional.

SKBI.1.4.5.3, 1989, “Defenisi Beton “

Vitri, Gusti dan Herman Hazmal, 2019, “Pemanfaatan Limbah Kelapa Sawit Sebagai Material Tambahan Beton” Universitas Dharma Andalas : Padang




DOI: https://doi.org/10.33559/eoj.v4i3.545

Refbacks

  • Saat ini tidak ada refbacks.


Jumlah Kunjungan

Negara Pengunjung

Flag Counter

Lisensi Creative Commons
Ciptaan disebarluaskan di bawah Lisensi Creative Commons Atribusi 4.0 Internasional.